Grass Valley 8943RDA User Manual
Page 18
18
8943RDA/-D/-DFR — Instruction Manual
Installation
Refer to the drawing in
for the following steps:
1.
Carefully slide the duplex ferrule end of the 2-channel fiber jumper
cable assembly into the end of the submodule until the duplex
connector snaps into place.
2.
Guide the two fiber jumper cables around towards the front of the
board and slip them through the plastic cable guides to hold them in
place.
3.
Find the ferrule end of the simplex (single) fiber jumper cable that
corresponds to the top duplex cable (labeled fiber 1 in the photo) and
connect it to the bottom of the rear fiber connector (labeled Fiber 1 in the
photo).
4.
Find the ferrule end of the simplex (single) fiber jumper cable that
corresponds to the bottom duplex cable (labeled Fiber 2 in the photo)
and connect it to the bottom (labeled Fiber 2 in the photo) of the rear
fiber connector.
5.
Also refer to
for an illustration of the fiber
connector on the rear module.
Figure 9. Installing Fiber Jumper Cables
Duplex cable end
Simplex cable ends