Grass Valley 8943RDA - Manual (Page 53)

8943RDA/-D/-DFR — Instruction Manual 53
Configuration
Configuration
The 8943RDA-D can be configured using the front edge onboard controls
or using the remote controls available with a web browser or a networked
Newton Control Panel.
The Input Operating mode for Channel 1 and Channel 2 must be set on the
Settings web page.
This module two coax inputs channel (CH 1 and CH 2) which four sets of
output coax pairs. Inputs can be mapped to output pairs on the Settings
web page.
Local Configuration
For Local configuration, follow the summary of instructions given in Local
Onboard Configuration on page 33 for using the front edge onboard switches
for configuration.
Remote Configuration
The remote configuration is summarized in Remote Configuration on
page 38 .
For the 8943RDA-D module, each of the available web pages are shown on
the following pages:
• Status ( page 54 )
• I/O Config ( page 56 )
• Settings ( page 58 )
• Slot Config ( page 60 )
Use
this
link