H3C Technologies H3C Intelligent Management Center - Manual (Page 106)

97
Creating an SLA
This configuration example uses system-defined KQIs and requires no service level setting. For more
information about configuring KQIs and service levels, see "Adding a KQI " and "Adding a service
level."
To create an SLA:
1. Click the Service tab.
2. From the left navigation tree, click Service Health Manager > SLA.
The SLA page appears.
3. Click Add and select Manually Add.
The page for adding an SLA appears.
4. Click Select Device to add Switch A, Switch B, the voice gateway, and the VCX server.
The devices appear in the Resource Topology area. NQA instances between Switch A, Switch B,
the voice gateway are also imported and represented in green dashed lines.
5. In the left area of the page, select the following KQIs and drag them to the area above the
Resource Topology area.
{
Select Device Response Time and Device Unreachable from the Device Status KQI class.
{
Select Voice MOS, Voice icpif, Average RTT, Jitter, one way average delay, Error Rate, Packet
Loss Rate, and Unreachable Rate from the NQA Voice Quality KQI class.