Configuring device a, N in, Figure 32 – H3C Technologies H3C SecPath F1000-E User Manual
Page 37
29
Figure 32 Configuring ACL 2010
•
Select Permit in Operation.
•
Select Source IP Address and enter 10.1.1.0 in the field.
•
Enter 0.0.0.255 in Source Wildcard.
•
Click Apply.
# Enable strict URPF check in zone B.
•
Select Intrusion Detection > URPF Check from the navigation tree and perform the following
operations, as shown in
Figure 33 Configuring URPF in zone B
•
Select zoneB in Security Zone.
•
Select Enable URPF.
•
Select ACL and enter 2010 in the field.
•
Select Strict in Type of Check.
•
Click Apply.
Configuring Device A
# Configure the interface IP addresses and security zones they belong to. (Details not shown.)
# Enable strict URPF check in zone A.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS