H3C Technologies H3C SecPath F1000-E - Manual (Page 20)

12
Figure 11 ICMP flood detection configuration page
To configure ICMP flood detection, follow these steps:
1. In the Attack Prevention Policy area, specify the protection action to be taken upon detection of an
ICMP flood attack. If you do not select the Discard packets when the specified attack is detected
option, the firewall only collects ICMP flood attack statistics.
2. In the ICMP Flood Configuration area, view the configured ICMP flood detection rules, or click Add
to enter the page shown in
Figure 12 to configure an ICMP flood detection rule. Table 5 describes
the configuration items.
Figure 12 Adding an ICMP flood detection rule