H3C Technologies H3C SecPath F1000-E - Manual (Page 22)

14
Figure 13 UDP flood detection configuration page
To configure UDP flood detection, follow these steps:
1. In the Attack Prevention Policy area, specify the protection action to be taken upon detection of a
UDP flood attack. If you do not select the Discard packets when the specified attack is detected
option, the firewall only collects UDP flood attack statistics.
2. In the UDP Flood Configuration area, view the configured UDP flood detection rules, or click Add
to enter the page shown in
Figure 14 to configure a UDP flood detection rule. Table 6 describes
the configuration items.
Figure 14 Adding a UDP flood detection rule
Table 6 Configuration items
Item Description
Protected Host
f
IP Address Specify the IP address of the protected host.