Arranging slots, Numbering interfaces, Examples – H3C Technologies H3C SecPath F1000-E User Manual
Page 83
75
Appendix C Arranging slots and numbering
interfaces
Arranging slots
The F1000-E/F1000-S-EI supports console, fiber, and copper ports. This chapter describes how these
interfaces are numbered.
Figure 62 Slot arrangement on the F1000-E
(1) Slot 0
(2) Slot 1
(3) Slot 2
Figure 63 Slot arrangement on the F1000-S-EI
(1) Slot 1
(2) Slot 2
Numbering interfaces
Except for the console port, interfaces on the F1000-E/F1000-S-EI are numbered in the form of
interface-type X/Y, where,
•
interface-type represents the type of the interface such as GigabitEthernet.
•
X represents the number of the slot where the interface module resides.
•
Y represents the sequence number of the interface on the interface module.
Note the following:
•
Interfaces on the same interface module have the same slot number X.
•
For each type of interfaces, the sequence number Y starts from 0 and increases according to the
sequence on the interface module (from left to right).
Examples
1.
The fixed fiber/copper ports on F1000-E are numbered as follows: