H3C Technologies H3C SecPath F1000-E - Manual (Page 55)

47
Figure 51 Removing an interface module
4. Install a new interface module.
For the installation procedures, see the chapter "
Installing an interface module ."
If no new interface module is to be installed, install a filler panel.
Replacing a CF card
CAUTION:
To avoid hardware damage, do not remove the CF card when the firewall is booting or the LED is
flashing.
To replace a CF Card:
1. Check whether the CF card LED is flashing. Proceed to the next step after the LED stops flashing.
2. Press the CF card eject button so that the eject button projects from the panel.
3. Press the eject button again to eject the CF card part-way out of the slot.
4. Pull the CF card out of the slot.
Put the removed CF card in an antistatic bag.