H3C Technologies H3C SecPath F1000-E - Manual (Page 56)

48
Figure 52 Removing a CF card
5. Install a new CF card.
For the installation procedures, see the chapter "
Installing a CF card ."
Replacing a transceiver module
WARNING!
•
When you remove a transceiver module, do not touch the golden finger on the module.
• Do not stare at the fibers to avoid hurting your eyes.
• Make sure the transceiver modules at the two ends of a fiber are the same type.
To replace a transceiver module:
1. Pressing the tab of the LC connector, pull out the LC connector from the transceiver module.
Put on the dust cap for the LC connector.
2. Pivot the clasp of the transceiver module down to the horizontal position.
3. Hold the clasp to pull the transceiver module out of the socket.