F1000-s-ei panel leds – H3C Technologies H3C SecPath F1000-E User Manual
Page 79
71
LED Status
Description
(green)
Off
No host is connected to the device-mode USB interface.
On
A host is connected to the device-mode USB interface. You can
remove the USB cable in this state.
Flashing
The device-mode USB interface is transmitting data or is in
operating. Do not remove the USB cable in this state.
Figure 55 F1000-E rear panel LEDs
Table 35 LED description
LED Status
Description
(yellow/green)
Off
No link is present on the port.
Steady green
A 1000 Mbps link is present on the port.
Flashing green
Data is being transmitted or received at 1000 Mbps on the port.
Steady yellow
A 10/100 Mbps link is present on the port.
Flashing yellow
Data is being transmitted or received at 10/100 Mbps on the port.
(yellow/green)
Off
No 1000 Mbps link is present on the SFP port.
Steady green
A 1000 Mbps link is present on the SFP port.
Flashing green
Data is being transmitted or received at 1000 Mbps on the SFP port.
Steady yellow
The transceiver module fails the POST or is not recognizable.
F1000-S-EI panel LEDs
Figure 56 F1000-S-EI panel LEDs
Table 36 LED description
LED Status
Description
(yellow)
Off
No data is being transmitted or received on the port.
On
Data is being transmitted or received on the port.
(green)
Off
No link is present on the port.
On
A link is present on the port.