H3C Technologies H3C SecPath F1000-E - Manual (Page 23)

15
• The firewall is ready for installation and has been carried to a place near the installation site and
convenient for moving.
Unpacking the firewall
Figure 14 Unpacking the firewall
Mounting the firewall on a workbench
IMPORTANT:
•
Ensure good ventilation and 10 cm (3.94 in) of clearance around the chassis for heat dissipation.
• Avoid placing heavy objects on the firewall.
To mount the firewall on a workbench:
1. Verify that the workbench is sturdy and well grounded.
2. Place the firewall with bottom up, and clean the round holes in the chassis bottom with dry cloth.
3. Attach the rubber feet to the four round holes in the chassis bottom.
4. Place the firewall with upside up on the workbench.
Installing the firewall in a 19-inch rack
Installing an F1000-E in the rack
To install the firewall in the rack:
1. As shown in Figure 15 , mark the positions of the cage nuts on the front rack posts by using a front
mounting bracket and on the rear rack posts by using a rear mounting bracket.