H3C Technologies H3C SecPath F1000-E - Manual (Page 45)

37
.......
System is starting.....
..........................................................................
User interface con0 is available.
Press ENTER to get started.
After pressing Enter, you are placed in user view:
Now, you can configure and manage the firewall.
Logging in to the CLI by using Telnet
This section provides only a simplified procedure for logging in to the CLI by using Telnet. For more
information, see the firewall configuration guides.
To log in to the CLI by using Telnet:
1. Log in to the firewall through the console port, execute the telnet server enable command in
system view to enable the Telnet service, and execute the user privilege level command in VTY
user interface view to specify the command level for Telnet users. By default, the Telnet service is
disabled on the firewall.
2. Connect a PC to the firewall's interface GigabitEthernet 0/0 by using a crossover Ethernet cable.
3. Assign the PC an IP address in the network segment 192.168.0.0/24 (except for 192.168.0.1),
for example, 192.168.0.2.
4. Run the Telnet client on the PC to Telnet to the firewall.
Logging in to the Web interface
An F1000-E or F1000-S-EI firewall supports Web login by default, and is provided with the default Web
login information shown in Table 7 .
Table 7 Default Web login information for F1000-E and F1000-S-EI firewalls
Item F1000-E F1000-S-EI
Username
h3c for versions prior to F3171P01.
admin for F3171P01 and later versions.
admin.
Password
h3c for versions prior to F3171P01.
admin for F3171P01 and later versions.
admin.
Interface GigabitEthernet 0/0 GigabitEthernet 0/0
Interface IP address 192.168.0.1 192.168.0.1
To log in to the Web interface:
1. Connect a PC to the firewall's interface GigabitEthernet 0/0 by using a crossover Ethernet cable.