H3C Technologies H3C SecPath F1000-E - Manual (Page 25)

17
Figure 18 Attaching the rear mounting brackets to the rack
4. Align the screw holes in one mounting bracket with the screw holes in the side panel of the
chassis, and use screws to attach the mounting bracket to the firewall, as shown in
Figure 19 .
Figure 19 Attaching the mounting brackets
5. Attach the two load-bearing screws supplied with the firewall to the two sides of the firewall.
Figure 20 Attaching the load-bearing screws
6. Supporting the bottom of the firewall with one hand and holding the firewall with the other hand,
slide the firewall into the rack until the rear mounting brackets can hold the firewall.