H3C Technologies H3C S5560 Series Switches - Manual (Page 87)

78
Table 25 RPS status LED description
LED mark Status Description
RPS
Steady green Both the RPS DC input and the AC input are normal.
Steady yellow
The RPS DC input is normal, but the AC input is disconnected or
has failed.
Off The RPS DC input is abnormal or no RPS is connected.
Port mode LED
To show more information about the switch through the port status LEDs, all S5560-EI switches except the
S5560-54QS-EI switch provides a port mode LED. The port mode LED indicates the type of information
that the network port LEDs are showing.
Table 26 Port mode LED description
LED mark Status Description
Mode
Steady green
The port status LEDs are showing
port rates.
Flashing green (1 Hz) (available only for
S5560-30C-PWR-EI and S5560-54C-PWR-EI
switches)
The port status LEDs are showing the
status of PoE power supply on the
ports.
Flashing yellow
The port status LEDs indicates the
IRF member ID of the switch. For
example, if the ports 1 to 5 are
steady green, the IRF member ID of
the switch is 5.
10/100/1000Base-T autosensing Ethernet port LED
The switch provides a status LED for each 10/100/1000Base-T autosensing Ethernet port. The port status
LED and the port mode LED indicate the operating state of the 10/100/1000Base-T autosensing
Ethernet port in conjunction.
Table 27 10/100/1000Base-T autosensing Ethernet port LED description
Port mode LED (Mode) status Port LED status Description
Steady green (rate mode)
Steady green
The port is operating at 1000
Mbps. The port LED fast flashes
when the port is sending or
receiving data.
Steady yellow
The port is operating at 10/100
Mbps. The port LED fast flashes
when the port is sending or
receiving data.
Flashing yellow (3
Hz)
POST has failed on the port.