H3C Technologies H3C S5560 Series Switches - Manual (Page 74)

65
Appendix B FRUs and compatibility matrixes
FRUs and compatibility matrixes
FRUs
S5560-30S-EI
S5560-54S-EI
S5560-30C-EI
S5560-54C-EI
S5560-30F-EI
S5560-30
C-PWR-EI
S5560-54
C-PWR-EI
S5560-
54QS-EI
Hot swappable power modules
PSR150-A1 N/A Supported N/A Supported
PSR150-D1 N/A Supported N/A Supported
PSR360-56A N/A N/A Supported N/A
PSR720-56A N/A N/A Supported N/A
PSR1110-56A N/A N/A Supported N/A
Hot swappable fan trays
LSPM1FANSA N/A Supported Supported Supported
LSPM1FANSB N/A Supported Supported Supported
Interface cards
LSWM2QP2P N/A Supported Supported N/A
LSWM2SP2PM N/A Supported Supported N/A
LSWM2SP8PM N/A Supported Supported N/A
LSWM2XGT2PM N/A Supported Supported N/A
LSWM2SP8P N/A Supported Supported N/A
LSWM2XGT8PM N/A Supported Supported N/A
The PSR360-56A, PSR720-56A, PSR1110-56A, PSR150-A1, and PSR150-D1 power modules support
asset management. You can use the display device manuinfo command to view the name, sequence
number, and vendor of the power modules you have installed on the device.
You can install one power module, or two power modules for redundancy on the S5560-30C-EI,
S5560-30F-EI, S5560-54C-EI, and S5560-54QS-EI switches. These switches support mix of an AC
power module and a DC power module.
You can install one power module, or two power modules for redundancy on the S5560-30C-PWR-EI
and S5560-54C-PWR-EI switches. The PoE capabilities of these switches vary by power module
configuration. For more information, see Table 11 .
All S5560-EI switch models except the S5560-30S-EI and S5560-54S-EI switches support hot swapping
of fan trays. You must install two fan trays of the same model for the switch. Do not power on the switch
when it does not have any fan trays or has only one fan tray installed.