H3C Technologies H3C S5560 Series Switches - Manual (Page 80)

71
USB port
The switch has one OHC-compliant USB2.0 port that can upload and download data at a rate up to 480
Mbps. You can use this USB port to access the file system on the flash of the switch, for example, to
upload or download application and configuration files.
NOTE:
USB devices from different vendors vary in compatibilities and drivers. H3C does not guarantee the
correct operation of USB devices from all vendors on the switch. If a USB device fails to operate on the
switch, replace it with one from another vendor.
10/100/1000Base-T autosensing Ethernet port
Table 15 10/100/1000Base-T autosensing Ethernet port specifications
Item Specification
Connector type RJ-45
Interface attributes
• 10 Mbps, full duplex
• 100 Mbps, full duplex
• 1000 Mbps, full duplex
• MDI/MDI-X, auto-sensing
Max transmission
distance
100 m (328.08 ft)
Transmission medium Category-5 (or above) twisted pair cable
Standards IEEE 802.3i, 802.3u, 802.3ab
100/1000Base-X SFP port
The S5560-30F-EI switch provides 24 fixed SFP ports on the front panel. You can install the 100 Mbps
SFP modules in
Table 16 and the 1000 Mbps SFP transceiver modules in Table 17 in the SFP ports.
Table 16 100 Mbps SFP transceiver modules available for the 100/1000 Base-X SFP ports
Module description
Central
wavelength
(nm)
Connecto
r
Fiber diameter
(μm)
Max transmission
distance
SFP-FE-SX-MM1310-A 1310 LC
Multi-mode, 50/125
2 km (1.24 miles)
Multi-mode, 62.5/125
SFP-FE-LX-SM1310-A 1310 LC Single-mode, 9/125 15 km (9.32 miles)
SFP-FE-LH40-SM1310 1310 LC Single-mode, 9/125 40 km (24.86 miles)
SFP-FE-LH80-SM1550 1550 LC Single-mode, 9/125 80 km (49.71 miles)
SFP-FE-LX-SM
1310-BIDI HP X110
100M SFP
TX: 1310
RX: 1550
LC Single-mode, 9/125 15 km (9.32 miles)