H3C Technologies H3C S5560 Series Switches - Manual (Page 39)

30
Figure 38 Connecting a DC power cord to the switch
Connecting the PSR150-A1
1. Wear an ESD wrist strap and make sure it makes good skin contact and is correctly grounded.
2. Attach the hooks of the bail latch (supplied with the power module) into the two holes next to the
power receptacle on the power module, and pull the bail latch leftwards (see Figure 39 ).
3. Connect one end of the AC power cord supplied with the power module to the power receptacle
(see callout 1 in
Figure 40 ).
4. Pull the bail latch rightwards to secure the plug to the power receptacle (see callout 2 in Figure 40 ).
5. Connect the other end of the power cord to an AC power outlet.
Figure 39 Connecting the PSR150-A1 (1)