H3C Technologies H3C S5560 Series Switches - Manual (Page 67)

58
Figure 69 S5560-54C-EI rear panel
(1) Grounding screw (2) Interface card slot
(3) Fan tray slot 1 (4) Fan tray slot 2
(5) Power module slot 1 (6) Power module slot 2
The S5560-54C-EI switch comes with power module slot 1 empty and power module slot 2 installed with
a filler panel. You can install one or two power modules for the switch as required. In this figure, two
PSR150-A1 AC power modules are installed in the power module slots. For more information about
installing and removing a power module, see " Installing/removing a power module ."
The S5560-54C-EI switch comes with the two fan tray slots empty. You must install two fan trays of the
same model for the switch. In this figure, two LSPM1FANSA fan trays are installed in the fan tray slots. For
more information about installing and removing a fan tray, see " Installing/removing a fan tray ."
The S5560-54C-EI switch comes with a filler panel in the interface card slot. You can select an interface
card for the switch as required. In this figure, an LSWM2QP2P interface card is installed in the interface
card slot. For more information about installing and removing an interface card, see
"
Installing/removing an interface card ."
S5560-54C-PWR-EI
Figure 70 S5560-54C-PWR-EI front panel
(1) 10/100/1000Base-T autosensing Ethernet port (2) 10/100/1000Base-T autosensing Ethernet port LED
(3) Management Ethernet port
(4) Console port
(5) USB mini console port (6) Port LED mode switching button
(7) USB port (8) System status LED (SYS)
(9) SFP+ port (10) Port mode LED
(11) Interface card status LED (SLOT) (12) Power module 2 status LED (PWR2)
(13) Power module 1 status LED (PWR1) (14) SFP+ port LED
(15) Management Ethernet port LED
1 2 3 4 5 6