Rack-mounting by, Using front mounting brackets and mounting, Rail assemblies – H3C Technologies H3C S5560 Series Switches User Manual
Page 23: S5560-54qs-ei), Figure 17
14
Figure 17 Mounting the switch in the rack
Rack-mounting by using front mounting brackets and mounting
rail assemblies (S5560-54QS-EI)
You can install the front mounting brackets at the port-side or power-side mounting position as needed.
This task requires two people.
To install the switch in a 19-inch rack by using the front mounting brackets and mounting rail assemblies:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is correctly grounded.
2.
Attach the front mounting brackets and the chassis rails to the chassis (see
a.
Unpack the front mounting brackets and the M4 screws for attaching the brackets to the switch
chassis.
b.
Align the round holes in the wide flange of one front mounting bracket with the screw holes in
the power-side mounting position on one side of the chassis.
c.
Use M4 screws (supplied with the switch) to attach the mounting bracket to the chassis.
d.
Align one chassis rail with the screw holes in the chassis rail mounting position.
e.
Use M4 screws (supplied with the switch) to attach the chassis rail to the chassis.
f.
Repeat the proceeding steps to attach the other mounting bracket and chassis rail to the other
side of the chassis.