H3C Technologies H3C S5560 Series Switches - Manual (Page 21)

12
mounting position as needed. The following takes port-side mounting as an example. The power-side
mounting is similar.
This task requires two people.
To install the switch in a 19-inch rack by using the front and rear mounting brackets:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is correctly grounded.
2. Attach the front mounting brackets and load-bearing screws to the chassis:
a. Unpack the front mounting brackets and the M4 screws for attaching the brackets to the switch
chassis.
b. Align the round holes in the wide flange of one front mounting bracket with the screw holes in
the port-side mounting position on one side of the chassis (see
Figure 14 and Figure 15 ).
c. Use M4 screws (supplied with the switch) to attach the mounting bracket to the chassis.
d. Repeat the proceeding two steps to attach the other mounting bracket to the chassis.
e. Unpack the load-bearing screws.
f. Install the load-bearing screws in one of the load-bearing screw mounting positions on both
sides of the chassis (see
Figure 14 and Figure 15 ).
Figure 14 Attaching the front mounting brackets and load-bearing screws to the chassis
(S5560-30C-PWR-EI/S5560-54C-PWR-EI)
Figure 15 Attaching the front mounting brackets and load-bearing screws to the chassis
(S5560-54QS-EI)