Epson 10020 User Manual
Page 96
2. Type
MENU at the command prompt and
press
Enter. You
see this main menu:
EXIT
File Utilities
Disk Utilities
Mode Settings
Help
Enter DOS Command
3. To select an option, use the arrow keys to highlight your
selection and then press Enter. Most options contain
submenus; keep highlighting your selection and pressing
Enter until you have selected the desired operation.
Because MENU works by calling other external commands, you
may occassionally see an error message similar to this when you
select an option:
SETPRINT.EXE not on the current disk.
Press
any key
to continue...
This message appears if you try to run MENU from a diskette
that does not contain the command called by MENU-in this
case, SETPRINT. (This does not happen on the Apex 100\20
because the hard disk is set up with a PATH command so
MS-DOS can find the appropriate command.)
If you see this message, insert the diskette that has the
command in the diskette drive and try again. (See “Types of
MS-DOS Commands” at the beginning of this chapter to
determine which commands are on which MS-DOS diskettes.)
Note
If you find that you frequently have to swap diskettes
while using MENU, see the description of MENU in your
MS-DOS Reference Manual for some recommended
solutions.
Using MS-DOS With Your Computer
3-37