Epson 10020 User Manual

Page 41

Then press

any key. The DISKCOPY program copies the

contents of the Startup diskette to the computer’s memory,
and then you see the following:

Insert TARGET diskette in drive A:

Press any key when ready . . .

Remove the Startup diskette and insert a blank diskette

(which is to be the target) in the drive. Then press any key.

If the diskette is not formatted, the DISKCOPY program

formats it. (Formatting prepares a diskette to store data and

is described in Chapter 3.) Then the program begins

copying the data from the computer’s memory to the

formatted diskette. When the copy is complete, you see
this prompt:

Copy

another diskette (Y/N)?

Press Y so you can make a copy of the Operating 1 diskette.
Again, you see the prompt to insert the source diskette.

Remove the copy of the Startup diskette, which you just

made, and insert the Operating 1 diskette in the drive.

Then press any key. Continue following the prompts on

the

screen

to make a copy of this diskette, as you did the

Startup diskette.

Repeat the procedure to copy the Operating 2 diskette and

then the Reference diskette.

When you finish copying the last diskette and the

Copy

another diskette (Y/N)?

prompt appears, press

N to return to the MS-DOS command prompt.

1-24

Setting Up Your System