beautypg.com

Run all above checks, D-35 – Epson 10020 User Manual

Page 192

background image

At the end of the test, you see a table of the results

of the test.

For example, for a 20MB hard disk with no bad tracks, you see:

BAD TRACKS ..............

0

READ ERROR TRACKS

.......

0

GOOD TRACKS

.............

2460

Press ENTER to return to the menu

Press Enter when you have viewed the table.

If the results show BAD TRACKS on your disk, it is all right

because those tracks will not be used. If, however, the results
show any READ ERROR tracks, run the destructive surface
analysis described in Appendix E

Run All Above Checks

To run all the tests on the menu in sequence, press 5 and then

Enter. When you choose this option, all checks for the hard

disk drives and controller are performed automatically in
sequential order. Although you do not start each test, you must
still supply the appropriate responses to progress from one test

to the next. The first prompt you see is:

The data on the highest physical cylinder

may be destroyed by this check.

Enter Y to start this check.
Enter N to return to the menu.

Press Y and then Enter to continue with the test.

Performing System Diagnostics

D-35