beautypg.com

Epson 10020 User Manual

Page 7

background image

FCC COMPLIANCE STATEMENT FOR AMERICAN USERS

This equipment generates and uses radio frequency energy and if not installed and

used properly, hat is, in strict accordance with the manufacturer’s instructions, may

cause interference co radio and television reception. It has been type tested and
found co comply with the limits for a Class B computing device in accordance with

the specifications in Subpart J of Part 15 of FCC Rules, which are designed co
provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio and television

reception, which can be determined by turning the equipment off and on, you are
encouraged co try co correct the interference by one or more of the following
measures:

l

Reorient the receiving antenna

l

Relocate the computer with respect to the receiver

l

Move the computer away from the receiver

l

Plug the computer into a different outlet so chat the computer and receiver are
on different branch circuits.

If necessary, consult your dealer or an experienced radio/television technician for

additional suggestions. You may find the following booklet prepared by the Federal

Communications Commission helpful:

“Television Interference Handbook.”

This booklet is available from the U.S. Government Printing Office, Washington,

DC 20402. Stock No. 004-000-00450-7.

Note: If the interference stops, it was probably caused by the computer or its

peripheral devices. To further isolate the problem: Disconnect the peripheral devices
and their input/output cables one at a time. If the interference stops, it is caused by
either the peripheral device or its I/O cable. These devices usually require shielded

I/O cables. For Epson peripheral devices, you can obtain the proper shielded cable

from your dealer. For non-Epson peripheral devices contact the manufacturer or

dealer for assistance.

WARNING: This equipment has been certified to comply with the limits for a
Class B computing device, pursuant to Subpart J of Part 15 of FCC Rules. Only

peripherals (computer input/output devices, terminals, printers, etc.) certified co
comply with the Class B limits may be attached to this computer. Operation with

non-certified peripherals is likely to result in interference to radio and TV

reception. The connection of a non-shielded equipment interface cable to this
equipment will invalidate the FCC Certification of this device and may cause

interference levels that exceed the limits established by the FCC for this

equipment.

This digital apparatus does not exceed the Class A/ Class B (whichever is applicable)

limits for radio noise emissions from digital apparatus as set out in the radio
interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant la

limites applicables aux appareils numériques de Classe A/de Classe B (selon le cas)

prescrites dans le règlement sur le brouillage radioélectriques édicté par le Ministère
des Communications du Canada.

iii