Visara UCT-L - Manual (Page 95)

Chapter 6. Using TN3270, TN5250, TN5250EP, 1451, VT220 and VT3270
707108-001 6-33
Setting up 1451
1. Click the button located in the lower left corner of the screen.
2. Select Program from the pop-up menu.
3. Select Emulators from the next pop-up menu.
4. Click on the 1451 entry.
5. Select Communications from the Setup menu.
• Connection Type – Select either a LAN or Serial connection. (Serial port not
available on 300.)
• LAN
– Host – Enter the Internet address of the 1451 server to which you wish to connect,
for example, 255.255.XXX.XXX.
– Port – If the host requires that a port number (other than port 23) be specified
when connecting, select the port number using the up and down arrows or by
typing the port in directly.
• Auto Connect – Select to auto connect at program start-up.
• Auto Login – Select to enable and configure auto login on connect.
• Auto Play Macro – Select the F# associated with the macro that should play upon
connection. The name of the macro (if previously named) will appear in the window
below the checkbox.
• Break Key – Selects command sent for BreakKey function when using LAN
connection.
• Initial State
– Scan On/Off/Once – Allows selection of how serial input data is handled when
emulator is started.