Visara UCT-L - Manual (Page 109)

Chapter 6. Using TN3270, TN5250, TN5250EP, 1451, VT220 and VT3270
707108-001 6-47
Setting up VT220
To setup a remote host:
1. Click the button in the lower left-hand corner of the screen. The application
menu will appear.
2. Click VT220.
3. Click Setup.
4. Click Communications from the Setup menu. This screen will appear:
• Connection Type – Select either a LAN or Serial connection. (Serial port not
available on 300.)
• LAN
– Host – Enter the Internet address of the VT220 server to which you wish to connect,
for example, 255.255.XXX.XXX.
– Port – If the host requires that a port number (other than port 23) be specified
when connecting, select the port number using the up and down arrows or by
typing the port in directly.
• Auto Connect – Select to auto connect at program start-up.
• Auto Login – Select to enable and configure auto login on connect.
• Auto Play Macro – Select the F# associated with the macro that should play upon
connection. The name of the macro (if previously named) will appear in the window
below the checkbox.
• Session Name – Enter the name to be displayed in the window title.
• Serial (Serial port not available on 300.)
– Host – Enter the Internet address of the VT220 server to which you wish to connect,
for example, 255.255.XXX.XXX.
– Configure – Select to display the Serial Communications Configuration Panel.
Enter the Baud rate, parity, data bits and stop bits for the serial connection.