Visara LINCS Configuration - Manual (Page 226)

208
LINCS Configuration
707023-003
RPQs LINCS C8.2 Central Control
DESCRIPTION STATUS
Pass Write Structured Fields to LU3 TN3287 Clients Disable
Prevent TN3270 Connect Panel if Host is Disabled Disable
Make Hard Disk priority higher Disable
Restrict TN3270 LU requests to those configured Disable
Use TERMINATE-SELF instead of Inbound UNBIND Disable
Support Wollongong Pathway TN3270 Client Disable
Channel Gateway support for early VTAM versions Disable
Send BELL char(07) when ASCII display Input Inhibited Disable
ESCON Loopback Mode Disable
Discard UDP Packets to ports 2xxx for CEB Disable
Convert Warm ACTPU to Cold ACTPU Disable
Enhanced Supervisor Password Protection Disable
Prevent print of LPD Banner Page Disable
Update display while security keylock is locked Disable
STK 4430 LMU Support Disable
Auto Jump Session on 5xx Reminder(dec,disable=0) 00
PF: 1-Menu 7-Back 8-Forw 10-Done
RPQs LINCS C8.2 Central Control
DESCRIPTION STATUS
Ignore all LU requests from TN3270 clients Disable
Only Supervisor Displays can enter Test Mode Disable
Maximize TN3287 response timer Disable
Do Not Disc ESCON SNA PU on CU Reset Disable
Delay NSNA LAN print until FF sequence received Disable
(Must configure Disk Buffering)
Don’t optimize outbound data to an ASCII Display Disable
Don’t send Restore Kybd to TN3270 Client for NonSNA end-of-chain Disable
Don’t send Restore Kybd to TN3270 Client for NonSNA Deselect Disable
TN3270 clients MUST specify an LUNAME Disable
Ignore ICMP Redirect Disable
Allow a user to commandeer a 3270 session already in use Disable
Assume all TN3270 clients support extended attributes Disable
Immediately Disconnect NonSNA Client Disable
Send TN3270 connection confirmation to device Disable
Allow alphanumeric input on TN3270 Connect panel Disable
PF: 1-Menu 7-Back 8-Forw 10-Done