Visara LINCS Configuration - Manual (Page 211)

193
Chapter 13. Device Options
707023-003
Enveloping Delay After CR
This is a data entry field which defines the number of DEL characters (X’7F’) to be sent after
carriage return (CR) or horizontal tab (HT) to allow the print head to be repositioned before
sending more data. The value may range from 0 to 255.
Enveloping Delay After FF
This is a data entry field which defines the number of DEL characters (X’7F’) to be sent after
a formfeed (FF) or vertical tab (VT) to allow the print head to be repositioned before sending
more data. The value may range from 0 to 255.
Default Device Profile
Default Device Profile LINCS C8.2 Central Control
.
.
.
panel will vary depending on which device panel you’re in
PF: 1-Menu 3-Def_Dflt 4-Cpy_Prof 5-Cpy_Fld 7-Back 8-Forw 9-Default 10-Done
While displaying the Device Profiles, pressing PF3-Def_Dflt will display the Default Device
Profile, which may be modified as desired. It can be applied to other Device Profiles in the
following ways:
• While displaying the default profile, you may apply all fields of the profile to all other
Device Profiles by pressing PF4-Cpy_Prof.
• While displaying the default profile, you may apply an individual field to all other
Device Profiles by moving to the field and pressing PF5-Cpy_Fld.
• While displaying a Device Profile (other than the Default Device Profile), pressing PF9
will default the Device Profile to the values defined by the Default Device Profile.
• When using PF4 to add a new Device Profile, the new profile will be initialized to the
values defined in the Default Device Profile.
Device Profile Assignments
The Device Profile Assignments panel allows you to assign your previously created device
profiles to particular ports. Keep in mind that:
A maximum of 4048 3270 LUs may be defined per LINCS node
It is not necessary to assign a device profile to ports which do not have a device attached. A
device attached to a port that has no device profile assigned to it will be inoperable.
The first time you enter this panel, the host assignments will be based on Device Profile 0.
You can overwrite these values, or use PF3 or PF9 to assign defaults.