Sundance SMT390-VP - Manual (Page 7)

Version 2.4 Page 7 of 55 SMT390-VP User Manual
Figure 23 – Control Register Read Sequence. .......................................................... 40
Figure 24 – Register Memory Map............................................................................. 41
Figure 25 – Clock Synthesizer Control Register (0x02)............................................. 42
Figure 26 – Clock Routing Register (0x03). ............................................................... 42
Figure 27 - Acquisition trigger register (0x06). ........................................................... 43
Figure 28 – ADC Setup Control Register (0x07)........................................................ 44
Figure 29 – Decimation Register (0x08)..................................................................... 44
Figure 30 – SHB control Register (0x08). .................................................................. 45
Figure 31 – Module Top View (Main Module). ........................................................... 46
Figure 32 – Module Bottom View (Main Module). ...................................................... 47
Figure 33 – Top View (Daughter-card)....................................................................... 47
Figure 34 - Bottom View (Daughter-card). ................................................................. 48
Figure 35 - Connector Location.................................................................................. 49
Figure 36 - Pinout FPGA JTAG cable. ....................................................................... 50
Figure 37 - Pinout MSP430 JTAG cable. ................................................................... 51
Figure 38 - SMT390 to SMT338-VP Interconnections. .............................................. 52
Figure 39 – Fixings ..................................................................................................... 52
Precautions (Please Read this!).
In order to guarantee that the SMT390-VP functions correctly and to protect the
module from damage, the following precautions should be taken:
- The SMT390-VP is a static sensitive product and should be handled accordingly.
Always place the module in a static protective bag during storage and transition.
- At all time, make sure that the heat generated by the system is extracted e.g. by
the use of a fan extractor or an air blower . Sundance recommends to use a fan (as a
reference : PAPST 8300 series - 12-Volts – 31.8 CFM) to blow across the PCI bus
when the board is used within a PCI system. This is vital not to damage any of
components.
- SHB and RSL connectors are similar but their use is really different.
Do NOT
connect an SHB and an RSL connectors together with and SHB cable ! This would
cause irreversible damages to the modules.