Scotsman Prodigy Plus D Series Service Manual - Manual (Page 48)

N0422, F0522, N0622, F0822, N0922, F1222, N1322, F1522
Air, Water or Remote Service Manual
December 2014
Page 48
Repair Procedures: Bearing And Breaker
Note: Removal of the auger, water seal, evaporator
and gear reducer w/ motor must begin at the top of
the assembly.
To Remove the Breaker Bearing Assembly:
1. Remove panels and disconnect electrical power.
2. Push back bail clamp and remove ice chute cover.
3. Unscrew and remove ice sweep.
4. Lift up and remove ice chute.
5. The breaker may be removed from the auger and
evaporator without disturbing the auger.
• a. Unscrew breaker cover from breaker (left hand
threads)
• b. Unscrew auger stud from top of auger.
• c. Unscrew 4 allen head cap screws holding breaker
to evaporator.
• d. Lift up, and remove breaker/bearing assembly
from auger & evaporator.
6. Service the bearing. Check for rust, rough spots
and damage.
• a. The bearing is pressed into the breaker, to
remove the bearing and replace it an arbor press is
needed.
• b. Replace lower seals before installing new bearing
in breaker.
Note: Seals must be pressed in with a tool, they will
not install by hand. A 2" PVC coupling works well as
an insertion tool. Seals install open side up.
Lip seals must be lubricated with food grade grease
prior to assembly.
Replace parts as required. Re-grease bearing with
Scotsman part no. A36808-001 bearing grease.
Replace top seal, and check the o-rings, replace if cut
or torn.
7. Reverse to reassemble: specific tools and materials
are required to install properly.
• a. Add food grade grease such as Scotsman
part number 19-0569-01 to the seal area before
installing on the auger.
• b. Check the seal to shaft areas for cuts, or rough
spots: none are permitted.
Apply Food
Grade
Grease Here