beautypg.com

Scotsman Prodigy Plus D Series Service Manual User Manual

Page 10

background image

N0422, F0522, N0622, F0822, N0922, F1222, N1322, F1522
Air, Water or Remote Service Manual

December 2014

Page 10

Place on Bin or Dispenser

If reusing an existing bin, be sure that the bin is

in good shape and that the gasket tape on the

top is not torn up. Water leaks, not covered by

warranty, could result from a poor sealing surface. If

installing a remote or a remote low side, a new bin

is recommended due to the high cost to the user of

replacing an old bin when a remote system is on top.

Install the correct adapter, following the directions

supplied with that adapter.

Hoist the machine onto the adapter.

Note: The machine is heavy! Use of a mechanical lift

is recommended.

Position the machine on the bin or adapter. Secure

with straps from the hardware bag packed with the

machine, or those supplied with the adapter.

Remove any plastic covering the stainless steel

panels.

Note: The standard machine set up includes visible

on and off switches. Those can be covered up by

changing the bezel in the front panel’s trim strip. A

cover-up bezel is included with the hardware bag.

Remove any packaging, such as tape or foam blocks,

that may be near the gear reducer or ice chute.

Level the bin and ice machine front to back and left to

right by using the bin leg levelers.

Unpacking & Install Prep

Panel Removal A or B Series

1. Locate and loosen the two screws at the front edge

of the top panel.

2. Pull the front panel out at the top until it clears the

top panel.

3. Lift the front panel up and off the machine.

4. Remove two screws at the front of the top panel.

Lift up the front of the top panel, push the top panel

back an inch, then lift to remove.

5. Locate and loosen the screw holding each side

panel to the base. Left side panel also has a screw

holding it to the control box.

6. Pull the side panel forward to release it from the

back panel.

Button Switch Bezel A or B Series

To change bezels: Remove the front panel, and refer

to the instruction label on the inside of the front panel.

Push snaps of standard bezel in and pull the bezel

out of the front panel trim strip.

Locate other bezel. Push into the trim strip from the

front until it snaps into place. Return the front panel to

its original position and secure it to the cabinet.

Panel Removal D Series

1. Locate and loosen the two screws at the bottom of

the front panel.

2. Pull the front panel out at the bottom until it clears.

3. Lower the front panel down and off the machine.

4. Remove two screws at the front of the top panel.

Lift up the front of the top panel, push the top panel

back an inch, then lift to remove.

5. Locate and loosen the screw holding each side

panel to the base. Left side panel also has a screw

holding it to the control box.

6. Pull the side panel forward to release it from the

back panel.

This manual is related to the following products: