OpenEye CM-410 - Manual (Page 37)

28561AA 27
ALARM INPUT SETUP
ALARM INPUT SETUP
------------------------
ALARM1 TYPE N.OPEN
ALARM2 TYPE N.OPEN
ALARM3 TYPE N.OPEN
ALARM4 TYPE N.OPEN
ALARM1 ACT NOT USED
ALARM2 ACT NOT USED
ALARM3 ACT NOT USED
ALARM4 ACT NOT USED
BACK
EXIT
Matches the Alarm sensor input to one of Preset positions. If an external sensor is
activated, camera will move to corresponding preset position when this item is
predefined.
Alarm × Type [Normal OPEN/Normal CLOSE]
Sets sensor input type.
Alarm × Action [NOT USED/PRESET 1~128]
Assign counteraction Preset position to each Alarm input.
PRESET SETUP
PRESET SETUP
------------------------
PRESET NO. 1
CLR PRESET CANCEL
LABEL123
CAM ADJUST GLOBAL
BACK
EXIT
Preset Number [1~128]
If a selected preset is already defined, camera moves to
pre-defined position and preset characteristics such as
Label and Relay Outputs show on monitor. If a selected
preset is not defined, “UNDEFINED” shows on monitor.
Clear Preset [CANCEL/OK]
Delete current Preset data
Edit Preset Scene Redefine current Preset scene position (i.e. PTZ).
Edit Preset Label Edits Label to show on monitor when preset runs. MAX. 10
alphabets are allowed.
CAM Adjust [GLOBAL/LOCAL]
WB(White Balance) and AE(Auto Exposure) can be set up
independently for each preset. There are 2 modes,
"Global" mode & "Local" mode. The Global mode means
that WB or AE can be set up totally and simultaneously for
all presets in "ZOOM CAMERA SETUP" menu.
The Local mode means that WB or AE can be set up
independently or separately for each preset in each preset
setup menu. Each Local WB/AE value should activate
correspondingly when camera arrives at each preset
location. During jog operation, Global WB/AE value should
be applied.
All Local WB/AE values should not change although the
Global WB/AE value changes. If “Local’’ is selected, Menu
to set WB/AE shows on monitor.