Ae setup (auto exposure) – OpenEye CM-410 User Manual
Page 35
28561AA
25
AE SETUP (AUTO EXPOSURE)
AE SETUP - GLOBAL
------------------------
BACKLIGHT OFF
DAY/NIGHT AUTO1
BRIGHTNESS 25
IRIS AUTO
SHUTTER ESC
AGC NORMAL
SSNR MIDDLE
SENS-UP
BACK
EXIT
Backlight
[ON/OFF]
Sets Backlight Compensation
Day/Night
[AUTO1/AUTO2/DAY/NIGHT]
AUTO1 exchanges Day/Night mode faster than AUTO2.
Brightness
[0~100]
Adjusts brightness of images. Iris, Shutter Speed and Gain
are adjusted automatically in correspondence with this
value.
IRIS
[AUTO/MANUAL(0~100)]
If Iris is set to Auto, Iris should have highest priority in
adjusting AE and Shutter Speed should be fixed.
If Iris is set to Manual, Iris should be fixed and Iris has
lower priority in adjusting AE, in comparison with others.
Shutter Speed
[ESC/A.Flicker/Manual(
×128~1/120000 sec)]
If Iris is set to Manual and Shutter Speed is set to ESC
(Electronic Shutter Control), Shutter Speed should have
highest priority. If Shutter Speed is set to A.Flicker, to
remove Flicker, Shutter Speed should be set to 1/100 sec.
AGC
[OFF/NORMAL/HIGH]
Enhances image brightness automatically in case that
luminance level of image signal is too low.
SSNR
[OFF/LOW/MIDDLE/HIGH]
Enhances images by filtering noise when the level of
Electronic Gain is too high and creates noise.
SENS-UP
[AUTO(2~128)/OFF]
Activates Slow Shutter function when luminance of image
(signal) is too dark.
It is possible to set up the maximum number of frames
stacked on one another by Slow Shutter function.