OpenEye CM-410 - Manual (Page 21)

28561AA 11
CABLING
Cabling Terminal Block
Power
Controller/ DVR
BNC
Monitor
IrDA
Sensor
Door
Switch
Sensor
POWER CONNECTION
• Check the voltage and current capacity of rated power carefully. Rated power is indicated on the back of the main unit.
Rated Power Input Voltage Range Current Consumption
AC 24V AC 17V ~ 29V 0.4 A
Grounding
The GND (ground) wire must be directly connected to the F.G. pin of the cabling terminal block. Failure to connect the ground can
cause damage and failure of the camera and may void the warranty.
If the connection of the GND wire causes video noise, use a video isolator. This is only necessary in some situations.
Power Wire Length Specifications
Wire Gauge Maximum Distance
22 178 feet
20 284 feet
18 451 feet
16 716 feet
14 1138 feet
12 1811 feet
10 2886 feet