OpenEye CM-410 - Manual (Page 15)

28561AA 5
DIP SWITCH SETUP
Before you install the camera, you should set the DIP switches to configure the camera ID and communication protocol.
CAMERA ID SETUP
1 2 3 4 5 6
ON
ON
7 8
TIP: See the Appendix for a complete
Camera ID switch setting table.
• ID number of camera is set using a binary number. Example is shown below.
Pin 1 2 3 4 5 6 7 8
ID Value 1 2 4 8 16 32 64 128
ex) ID=5 on off on off off off off off
ex) ID=10 off on off on off off off off
• The range of ID is 1~255. Do not use 0 as camera ID. Factory default of
Camera ID is 1.
• If you want to control a certain camera, you must match the camera ID with
Cam ID setting of DVR or Controller.
COMMUNICATION PROTOCOL SETUP
1 2 3 4
ON
ON
• Select the appropriate Protocol with DIP switch combination.
Switch State
Protocol P0
(Pin 1)
P1
(Pin 2)
OFF OFF PELCO-D, 2400 bps
ON OFF PELCO-D, 9600 bps
OFF ON PELCO-P, 4800 bps
ON ON PELCO-P, 9600 bps
• If you want to control using DVR or P/T controller, their protocol must be
identical to camera. Otherwise, you cannot control the camera.
• If you changed camera protocol by changing DIP S/W, the change will be
effective after you reboot the camera.
• Factory default of protocol is “Pelco-D, 2400 bps”.
Camera ID Communication
Protocol