OpenEye CM-814 - Manual (Page 75)

30101AB 75
•
ExpComp – Define the value of Exposure Compensation (1~15).
•
Freeze – Freeze function allows you to hold the image while the camera is moving
between preset positions such as in Preset mode and Sequence mode (On/Off).
•
Flip – track an object continuously when it passes under the camera by setting Flip
to Mechanical (M.E.) mode or Digital Flip (Image) mode.
Note Flip setting is manual-controlled only. If a Preset Position or a point for other
function (ex. Sequence) is set in the position that can only be reached through
FLIP motion, the Flip function must be enabled for the camera to move to that
position.
Note To make the Dome Camera tilt between a specific range, such as -10° to
+100° or -10° ~ +190°, please go to the Tilt Range setting page to set the
tilt angle range. Otherwise, the Dome Camera will tilt 90° as the default
setting.
•
M.E. Mode – M.E. is a standard mechanical operation. As the Dome Camera tilts to
the maximum angle, it will pan 180°, and then continue tilting to keep tracking
objects.
•
Image Mode – Image represents digital IMAGE FLIP, which enables the camera to
keep tracking objects seamlessly. With the Image mode, almost no delay occurs in
comparison to the M.E. mode.
Note The Privacy Mask function will be automatically disabled if the Image Flip
function is enabled.
•
Digital Zoom – The camera supports up to 12x Digital Zoom.
•
ICR Function – The camera uses the IR cut filter to capture a clear image at night
time or in low light conditions. In the Auto mode, the internal circuit will automatically
decide when to remove the IR cut filter according to the image brightness level.