OpenEye CM-814 - Manual (Page 48)

48
Alarm Status Settings
The specific alarm pin’s property can be programmed in this section as shown below.
Alarm Switch
•
Alarm Switch – Enable or disable the alarm function.
•
Alarm Type – Select an alarm type, Normal close or Normal open, that
corresponds with the alarm application.
Alarm Action (Multi-option)
Specify alarm actions that will take place when the alarm is triggered.
•
Enable Alarm Output – Select this option to activate the alarm output.
•
Send Message by FTP/E-Mail – Select to send an alarm message by FTP and/or
E-Mail when this specific alarm is detected.
•
Upload Image by FTP – Select to assign an FTP site. When the alarm is triggered,
event images will be uploaded to the configured FTP site.
•
Upload Image by E-Mail – Select to assign an e-mail address. When the alarm is
triggered, event images will be sent to the configured e-mail address.
Note Make sure SMTP or FTP configuration has been completed. See the Mail and
FTP section of this manual for further details.