OpenEye CM-814 - Manual (Page 67)

30101AB 67
Sequence Setting
1. Click Edit under Sequence Setting to open the Sequence setting options.
2. Select the number of the new sequence line from the Sequence Line list at the top
of the screen.
3. Select each Preset Point of the programmed Sequence Line in order, selecting a
Preset Point from the Name list for the specified number of Preset Point
4. Enter the Dwell Time (0~225) and Speed (0~20) in the corresponding boxes.
5.
Sequence Run
•
Select the desired sequence from the list under Sequence Run and click Go.
•
To view the camera in full screen mode, move the cursor onto the live view pane,
right-click and select fullscreen.
•
To stop running the Sequence, move the cursor to the live view pane and use the
PTZ controls to move the camera in any direction.