OpenEye CM-814 - Manual (Page 65)

30101AB 65
Auto Pan Setting
To create an Auto Pan Path:
1. Select a path number from the Auto Pan Path list.
2. Move the cursor to the live view pane, and move the camera to a desired view as
the Start Point of an Auto Pan Path.
3. Click the “Set” button of the “Start Point”, and the current view will be automatically
saved as the start point of the Auto Pan Path.
Note The room ratio of an Auto Pan’s Start Point will persist throughout the whole
path.
4. Enter the speed ratio in the Speed box; the speed ratio ranges from 0 (low) to 3
(fast).
5. Select the Direction of the Auto Pan Path, Left or Right.
6. Move the camera to the desired end point position and click Set next to End Point.
Auto Pan Run
•
Select the specified path from the list under Auto Pan Run and click Run.
•
To view the camera in full screen mode, move the cursor onto the live view pane,
right-click and select fullscreen.
•
To stop running an Auto Pan Path, move the cursor to the live view pane and use
the PTZ controls to move the camera in any direction.