Nortec SE Series - Manual (Page 41)

Start Up | 38
Press. In is the boiler steam supply pressure.
Analog Output Information
Output Signal is the signal currently being output to the actuator.
Capacity is maximum output based on actual boiler steam press.
Total O/P is the current output of the humidifier.
Tank Monitor indicates if tank monitoring is On/Off.
Quick Warm indicates if Quick Warm is On/Off.
Press Base indicates if output is based on actual steam pressure.
Tank Status
Fill Valve indicates if the fill valve is open or closed.
Drain pump indicates if the drain is on or off.
Float level indicates the current float level.
Run Time is total weighted operating hours since last service.
Serv Time is the service interval set for the humidifier
Serv Due is the time remaining before service is required.
Sensor Inputs
Sec. Loop indicates if the security loop is open or closed.
Tank Temp indicates if the tank is cold (open) or hot (closed)..
Features List
Idle Mode indicates what the humidifier is configured to do when
there is no demand.
FTBD indicates if full tank blow down is enabled.
BD Rate indicates water drained for scale control as % of output
Drain Cool indicates configuration of drain water cooling feature
Float Check indicates if the humidifier will perform float checks.
Operational Hours
Total indicates the number of hours the humidifier has been
producing steam.
Weighted indicates the total amount of steam the humidifier has
produced expressed as number of hours running at 100% output.
Trend Graph
This graph provides a history of the humidifiers output for the past
4 hours. It displays a percentage of full output which corresponds
to the demand signal. The current demand signal is displayed at
the bottom of the screen.
Analog Output
Output Signal
: X.X VDC
Capacity : xxx lb/hr
Total O/P : xxx lb/hr
Tank Monitor : On/Off
Quick Warm : On/Off
Press. Base : On/Off
Menu
100%
0%
-4 hrs 0 hrs
Demand: 45%
Menu
TANK STATUS
Fill Valve
: ON/OFF
Drain Pump : ON/OFF
Float Level : 5
Run Time : xxx hr
Serv. Time : xxx hr
Serv Due : xxx hr
Menu
SENSOR INPUTS
Sec. Loop
: Closed
Tank Temp. : Closed
Menu
FEATURES LIST
Idle Mode
: Idle Drain
FTBD : On/Off
Time Prop. : On/Off
BD Rate : 25%
Drain Cool :On/Off/Smart
Float Check : On/Off
Menu
FEATURES LIST
Idle Mode
: Idle Drain
FTBD : On/Off
Time Prop. : On/Off
BD Rate : 25%
Drain Cool :On/Off/Smart
Float Check : On/Off
Menu