Measurement Computing DAC488 v.1 - Manual (Page 8)

2 DAC488 Overview DAC488 User’s Manual
Accessories
Additional accessories that can be ordered for the DAC488 include:
•
CA-1: Power Cable
•
CA-7-1: 1.5 foot IEEE 488 Cable
•
CA-7-3: 6 foot shielded IEEE 488 Cable
•
CA-7-4: 6 foot reverse entry IEEE 488 Cable
•
CA-8-20: 6 foot, 20 conductor ribbon cable with a card edge connector on one end, the other end
unterminated.
•
CA-35-2: 2 foot, DB25 male-to-female pin Connector
•
CA-35-6: 6 foot, DB25 male-to-female pin Connector
•
CN-40-12: DAC488 Analog Output Connector
•
CN-6-20: 20-pin card edge Connector.
•
CN-20: Right Angle IEEE 488 adapter, male and female
•
CN-22: IEEE 488 multi-tap bus strip, four female connectors in parallel
•
CN-23: IEEE 488 panel mount feed-through connector, male and female
Specifications
CAUTION CAUTION CAUTION CAUTION
Please read this manual carefully! If equipment is used in any manner not specified in
this manual, the protection provided by the equipment may be impaired.
WARNING WARNING WARNING WARNING
Do not use the DAC488 unit outdoors! This unit is intended for indoor use only!
Unexpected outdoor conditions could result in equipment failure, bodily injury or
death!
Digital I/O
Terminal Installation Category: Standard: Not Applicable. CE: Category 1.
Transistor-Transistor Logic (TTL) Levels: Digital outputs will drive 2 TTL loads or sink 100mA
(selectable using internal configuration jumper).
Digital Inputs and Digital Outputs: 8 inputs, TTL level compatible; 8 outputs, internally selectable TTL
level compatible or open collector with 100 mA @ 50 V drive capability.
Service Request/External Trigger Input: 1 line, TTL level compatible.
Connectors: Standard: One 20-pin card edge connector. CE: One DB25 (25-pin) connector.