D-Link DES-3225G User Manual
Page 96
24-port NWay Ethernet Switch User’s Guide
86
Using the Console Interface
Figure 6-57. Port Traffic Statistics screen
Select the desired setting in the Ports field: 1 to 4, 5 to 8, 9 to 12, 13 to 16, 17 to 20, 21-S1P2, or Slot 2 and the
desired increment setting in the Polling Interval field: 2 sec, 5 sec, 15 sec, 30 sec, 1 min, or Suspend. Pressing
CLEAR COUNTER resets the counters on this screen.
The statistic counters displayed are defined as follows:
♦
Speed
If the link is up, the speed and duplex status will be displayed; if the link is down “-” will be displayed.
♦
% Utilization
This shows the percentage of available bandwidth each port is using over the amount of time
specified by the update interval. For example, when a 10 Mbps port is relaying packets at 5 Mbps, the utilization is
50%.
♦
Bytes Recv.
The number of good bytes received. This also includes local and dropped packets.
♦
Bytes Sent
The number of good bytes sent from the respective port.
♦
Frames Recv.
The number of good frames received. This also includes local and dropped packets.
♦
Frames Sent
The number of good frames sent from the respective port.
♦
Total Bytes Recv.
The number of bytes received, good and bad.
♦
Total Frames Recv.
The number of frames received, good and bad.
♦
Last Seen MAC
The MAC address of the last device that sent packets over this port.