D-Link DES-3225G - Manual (Page 84)

24-port NWay Ethernet Switch User’s Guide
74 Using the Console Interface
Figure 6-46A. Static Multicast Forwarding Table screen
To add an entry or make a change to an entry on the Static Multicast Forwarding Table, enter a VLAN ID, enter a
MAC address, choose Egress or Forbidden for each port, choose a State (Delete on Reset, Delete on Timeout, Invalid,
or Permanent), and then press APPLY to put the change into effect.
Items in the above window are defined as follows:
♦ VID This is the VLAN that will be defined on this screen. Note a VLAN ID is from 1 to 4094.
♦ MAC Address The MAC address of the newly created Static Multicast Forwarding Table entry.
♦ Egress/Forbidden Position the cursor over the dash “-“ representing the appropriate port number and press the
to select E for Egress, F for Forbidden, or leave the dash “-“. An E designates the specified port as a static
member of the VLAN. A dash means the port is not given VLAN membership for the VID entered above. An F forbids
the port from joining a VLAN dynamically.
♦ State Choose how you want the Switch to deal with the newly created Static Multicast Forwarding table entry:
Delete on Reset , Delete on Timeout, Invalid, or Permanent.
When Port-Based VLANs, MAC-based Broadcast Domains, or None are selected on the VLANs & MAC-based
Broadcast Domains Configuration screen, the following Static Multicast Forwarding Table screen appears: