Place on sheet, Printer, Medium – KIP Graphics Pro User Manual

Page 45: Print mode, Filter, Kip graphics pro

KIP Graphics Pro

No part of this publication may be copied, reproduced or distributed in any form without express written permission

from KIP.  2015 KIP. v1.

- 45 -

The image will be increased or decreased. Either width or height will fit to media size and the opposite value will be smaller
than the media size. With the position field you can decide where the origin is placed to start the calculation. The scaling factor
is calculated automatically.

Place on Sheet

Here you can define the scale factor yourself. The result will be placed on the chosen position. If the media is bigger, you will
have white area around. If the media size is smaller, the print will be clipped.

Printer

Select the desired output device from the drop down list which contains all installed printers and queues.

The button next to the printer list opens the window for the printer/queue configuration. The dialog for the printer
configuration is device-dependent:

In the tab

R I N T

P T I O N S

you can change the settings of your printer. In the tab

L A C E M E N T

you set additional

arrangements of the picture. In the tab

O S T

R A C K I N G

you may enter information for KIP Track. If values are

mandatory, KIP Color RIP will open the dialog during job submission.

Medium

A selection of different media is displayed under

E D I U M

. Select the paper type you want to use for your output.

All calibrated paper types are displayed with black letters, whereas the paper types with red fonts have not been calibrated yet
or are not available for the selected printer. A description of the problem is shown when pointing to the medium name.

You will only be able to start the output if you have selected a calibrated paper type.

The list of media can individually be set and calibrated for every printer by clicking on the configuration button left of
the media drop down list. It will take you to the

O N F I G U R A T I O N

O A D E D

O N S U M A B L E S

as known from

ONFIGURATION

IZARD

. There is again the possibility to

D I T M E D I A

by using the corresponding button which takes

you to the

E F I N E

E D I A

dialog.

Print Mode

Select the print mode. You may choose color or gray scale / b/w mode.
The availability of selections is file and device dependent.

Filter

Select the corresponding color mode. You may choose color, gray scale or b/w mode. The availability of selections is file
dependent.

You can then select a

I L T E R

from the drop down menu. Filters are procedures to alter the visual shape of an image. All filters

that were saved in the filter archive are displayed in the drop-down list under

I L T E R

and can be selected from there.

The Filter

* N

I L T E R

means no filter is in effect.

The filter

* C

U R R E N T

is a temporary filter with the settings made in the

I L T E R

D I T O R

which have not been saved yet.