Hoefer IEF100 - Manual (Page 47)

• p41
Subset of HyperTerminal Commands
Format of
Command Command Description Expand Description Result of Command Command
AT Check connection Check to see if the connection “OK” comes back AT
between HyperTerminal and the with a good connection.
IEF100 is good and configured
properly.
XDATALOG Transfer data Transfer data from the IEF100 Data log shows up in XDATALOG
memory to HyperTerminal. HyperTerminal.
Output Data Format
Line 1 Header prot#,protname,startdate,starttime,#datapoints
Line 2 datapoints minute,volt,μAC1,μAC2,μAC3,μAC4,μAC5,μAC6,temp
End Line END,enddate,endtime
Where µAC1 is the current in microamps in channel 1.
IPROT Import protocol Import and overwrites one of the 30 Uploads protocol into 2 line formats
protocol slots: transfers protocol from IEF100 memory. depending on
computer to IEF100. step type
Input Data format
Delay step – IPROT,prot#,protname,step#,delaytime,delaytemp,runtemp,maxμA,maxA,maxVolt,maxWatt
IPROT,5,18cm const Watt,D,0:00,20,20,500,12000,1.5
Step – IPROT,prot#,protname,step#,steptype,stepvalue,timeunits,timeunits,time
IPROT,5,18cm const Watt,2,W,1.5,V,25000
EPROT,# Export protocol Copies protocol number # from Protocol appears in EPROT,#
IEF100 to HyperTerminal. HyperTerminal window. (# is 1–30)
EPROT, Export all protocols Copies all 30 protocols from Protocol appears in EPROT,
IEF100 to HyperTerminal. HyperTerminal window.
PrnRate,# Data interval setting Changes interval between data points INTVL in IEF100 PrnRate,#
(1–15 minutes). will update. (# is 1–15)
Start,#1,#2 Start protocol Starts protocol #1 with #2 IPG strips. IEF100 will start focusing. Start,#1,#2
(#1 is 1–30)
(#2 is 1–6)
Start Resumes protocol Restarts a protocol in a paused state. IEF100 will resume focusing. Start
Stop Stop protocol Stops a protocol in progress. IEF100 will terminate focusing. Stop
Pause Pause protocol Pauses a protocol in progress. IEF100 will pause focusing. Pause
Report Sends current status. Sends current run data, Report
if actively focusing, sends
current run data, if paused,
sends a paused message,
if not running, prints “idle”.
ID? Sends serial number. Transfers IEF100 serial ID?
number to the computer.