Hoefer IEF100 - Manual (Page 32)

• p26
9
Connect the (–) electrode to the (–) terminal (Fig. 25).
0
Place the (–) electrode on top of the electrode wicks so that the platinum
wire is centered in the area of overlap between the wicks and the IPG strip
(Fig. 26).
The electrode should lightly lock into place.
!
Cover the strips and any empty channels with 60 ml mineral oil. Using less
oil will risk that IPG strips will not be completely covered and may dry out
during the run (Fig. 27).
Fig. 25. Connect (–) electrode.
Fig. 26. Lock (–) electrode in place.
Fig. 27. Cover with mineral oil.