beautypg.com

Run screen – Hoefer IEF100 User Manual

Page 37

background image

• p31

Run Screen

The run screen displays all the information on the current run
(Fig. 33). There are no editable fields. The information on the run
screen is described below.

Line 1
The protocol number and name are shown. The top right corner indicates the
run status as either running (flashing), paused or finished.
Line 2
Displays the number of IPG strips being focused (or number of channels if
using the Dual Electrode Accessory).
Line 3
Describes the active step; the step number, the step value (volt or watt/strip)
and the step end point (Hrs or Vhrs).
Line 4
Displays the total elapsed time and the total volt-hours of focusing up to
the moment.
Line 5
Displays the total elapsed time and total volt-hours of the active step.
Line 6
Displays the real time output conditions of all the strips, including the
current volts, the total current, the total watts and the platform temperature.
Line 8 –13
Display the individual strip current and watts.

Fig. 33. Run screen.

Note: The IEF100 can only control
the conditions of one focusing tray
channel at a time. The IEF100 limits
the channel with the highest current,
or watts. IPG strips prepared under
identical conditions will show variations
due to geometrical differences in the
IPG gel and contact differences under
the electrodes. IPG strips with different
samples can show large differences in
current and wattage due to different
conductivities of the samples.