Harken 7411.11 1/2 MKIV Jib Reefing & Furling - Manual (Page 42)

Confirm Gap Between Deck Flange and Tack Swivel
Check to make sure there is a 1/16"–1/8" (2–4 mm) gap
between the deck flange and tack swivel. If necessary
loosen adjusting nut below and take up on turnbuckle
to increase gap between deck flange and tack swivel
when turnbuckle is tightened.
Storage – Mast Down
In areas where it freezes, do not store system where water
can accumulate in foils. When water freezes it will rupture
aluminum. Store foils under cover, with grooves facing down or on an angle so water will run out.
Storage/Transporting
Do not store or transport system with drum assembly extending beyond mast. Remove masthead clevis pin and
shift furler up so drum assembly can be strapped securely to mast. Some people remove drum assembly and
halyard swivel for storage and transport.
After Storage or Transport
After storing or transporting unit, clean thoroughly including ball bearings. See instructions above.
Remove Furler From Boat
In order to prevent foils from locking against upper stay terminal when backstay is released, loosen torque tube screws
and lower foil before loosening backstay.
Clean and Lubricate
Keep unit clean. When you wash boat, flush unit with
soap and fresh water. Occasionally lower sail and
flush halyard swivel with soap and fresh water.
At least twice a year unit should be cleaned more
thoroughly by removing line (first note direction of
spool) and flushing bearings with soap and fresh
water. After unit has dried, apply a dry spray lubricant
such as McLube ® .
Foils may be cleaned by washing with soap and water.
A scrap of luff tape may be run up foil to scrub inside
grooves. If lubrication is required, spray a thin coat of
McLube ® SailKote on sail luff tapes away from boat deck.
Inspect
Inspect unit for signs of chafe, wear, or damage.
Inspect locking devices below drum and inside torque tube
for signs of loosening. Check headstay tension for signs of
loosening.
Inspect swage fitting and lower toggle for signs of stress
corrosion.
Inspect Norseman or Sta-Lok
® terminal or rod terminal for
signs of loosening.
Inspect all screws on unit to be sure they have not loosened.
Inspect foil to make sure that it has not dropped into torque
tube. Periodically inspect wire for signs of wear or unraveling.
Maintenance Clean/Inspect/Remove Furler
42 MKIV Underdeck Unit 1, 2, 3
Check to
make sure
there is
a 1 / 16 "– 1 / 8 "
(2 - 4mm)
gap
WARNING! Periodically inspect items listed
below and any others as necessary. Failure
to inspect can cause an accident.
WARNING! Do not spray foil on boat. McLube ®
will cause slippery decks which may result in
loss of footing, falling overboard.