Harken 7411.11 1/2 MKIV Jib Reefing & Furling - Manual (Page 41)

Operation Race Conversion
Race conversion allows use of both
grooves for sail changes and tacking
genoas on deck for use of maximum
luff length genoas.
Halyard Swivel Off Furler
Serious racers may want to remove the
halyard swivel.
1) Remove drum assembly.
2) Rig a secure, temporary headstay.
3) Loosen backstay, mainsheet and vang
so that headstay goes slack.
4) See procedure on pages 29 - 31.
Note: It is not possible to remove halyard
swivel on a unit with a Norseman/Sta-Lok ®
or rod adapter stud unless you disassemble
terminal stud. Make sure you use a new
Norseman/Sta-Lok ® wedge to reassemble
Norseman/Sta-Lok ® fitting.
Halyard Swivel Below Feeder
Use halyard to lift halyard swivel up, away
from feeder. Loosen screw one revolution
only. Slide screw up and hold. Remove
feeder carefully—bottom end first. Don’t
lose the feeder overboard! Lower swivel
onto torque tube. Replace feeder.
Remove Feeder
Loosen screw one revolution only. Slide screw up and hold.
Carefully remove feeder–bottom
end first. Don't drop the feeder
overboard!
1.
2.
1. Loosen screw
one revolution only.
2. Slide screw up.
Remove feeder.
3. Lower halyard
swivel.
To Remove
Feeder For
Racing
MKIV Underdeck Unit 1, 2, 3 41