Harken 7411.11 1/2 MKIV Jib Reefing & Furling - Manual (Page 25)

Assembly Foils/Connectors
Use bushings, connector, wedge and
adhesive in other screw hole and
insert into other foil. Use adhesive (see
chart below for amount).
Inject only a small amount of adhesive
into middle hole. See chart below for
amount.
Tip: When you see a small amount of
adhesive enter one of the screw holes,
stop. You have applied enough adhesive.
Use “ml”
marks to
estimate
adhesive
Stop when you see a small
amount of adhesive enter
one of the screw holes.
Unit Adhesive (ml)
1 1 / 3 – 1 / 2
2 3 /4 – 1
3 (3/4, 7/8) 1 – 1 1 / 4
Unit Adhesive (ml)
1 1 / 3 – 1 / 2
2 3 /4 – 1
3 (3/4, 7/8) 1 – 1 1 / 4
MKIV Underdeck Unit 1, 2, 3 25
Tighten screws into connector holes. Make
sure a drop of red Loctite ® entered each
screw hole. If not, apply to screw.
Red Loctite ®